opet Lubricants Heavy Duty Vehicle Lubricants Engine Oils FULLPRO HT LSPS 10W-40 Fullpro HT LSPS 10W-40, is a synthetic diesel engine oil which is developed to meet lubrication requirements of modern heavy commercial vehicles. Low sulphated ash, phosphorus and sulphur (Low SAPS) content improves efficiency of exhaust gas after treatment systems such as Diesel Particulate Filter (DPF). Product Size 20L 205L Technical Data Sheet Safety Data Sheet Technical Support
FULLPRO HT 5W-20 FULLPRO HT SYN LD 5W-20 FULLPRO HT SYN LD 5W-30 FULLPRO HT SYN 10W-40 FULLPRO HT LSPS 5W-30 FULLPRO HT LSPS 10W-40 FULLPRO HT MSPS 10W-30 FULLPRO HT MSPS 15W-40 FULLPRO HT MSPS GAS 15W-40 FULLPRO HT 10W-40 FULLPRO HT CI-4 15W-40 FULLPRO GEO 15W-40 FULLMASTER TURBO 15W-40 FULLMASTER 10W-40 FULLMASTER 15W-40 FULLMASTER 20W-50 FULLMONO XH 10W FULLMONO XH 30 FULLMONO HD 10W FULLMONO HD 30 FULLMONO HD 40
Engine Oils In case of oil loss, is it possible to add oil to another brand? As a general principle, mixing of oils with different properties and different brands is not appropriate. However, the decrease in oil was a variety of reasons and if it is necessary to complete the same viscosity and quality class can be added with other brand oils. It is recommended that the oil is completely drained and replaced with new oil at the most convenient time after the addition with another brand of oil. Hydraulic brake fluid at the same quality level can be mixed with each other regardless of brand. Does oil change kilometer vary according to the type of engine oil? In many respects, synthetic oils have superior properties than mineral oils. Long life is one of them. Compared to mineral oils, synthetic oils as a general principle it can be said to have the better extended oil drain intervals. However, the oil change intervals are determined by the vehicle manufacturers (OEMs) after a series of tests. Compliance with these oil change intervals is the best in terms of equipment health. What is the aim of lubrication? The aim of lubrication is to decrease friction by separating two surfaces, to ease movement by lubricating surfaces, to make cooling, to minimize wear and to avoid corrosion by generating film on the surface. Gear Oils What is the difference between synthetic oil and mineral oil? Synthetic based oils are oils produced with chemical methods. They are produced to lubricate in applications where traditionally obtained mineral oils cannot be sufficient. Synthetic-based oils provide superior protection at higher temperatures than minerals, easier flow and pumpability at low temperatures , more stable film strength under extreme pressure and longer drain interval in difficult operating conditions. What does GL - 5 on gear oil packages mean? It is the API classification used for gear oils. Oil that contains additives to balance excessive pressure and pulsed load for hypoid gear type differentials running under heavy conditions and that fulfills MIL-L-2105 specifications. In GL-5, there are more overpressure additives and it is generally used under heavy work conditions. Unless otherwise specified, GL-5 should not be used in places where GL-4 is recommended. Because the sulphide in overpressure additive which is present excessively in GL-5 corrodes yellow metals. What is automotive gear lubricant SAE viscosity classification? The Association of Automotive Engineers (SAE) classifies automotive gear oils according to their kinematic viscosity values at 100 °C and their pumpability at low temperatures. For example, the SAE 80W-90 in an automotive gear oil '90' describes the kinematic viscosity of this gear oil at 100 °C. As this number increases oil thickens, if the number decreases oil thins. The kinematic viscosity of '90' gear oil at 100 °C is between 13.50 and 18.50 cST while the kinematic viscosity of '140' gear oil at 100 °C must be between 24.00 and 32.50 cST. The number to the left of W (Winter) determines the performance of gear oil at low temperatures. Pumping temperature of '80W' gear oil is -26 °C while pumping temperature of '75W' gear oil is -40 °C. Engine Oils What does 0W mean? 0W, expresses the viscosity grade of the engine oil. 'W' comes from the word 'winter'. '0' shows the cold working conditions of the engine oil. The kinematic viscosity of a 0W engine oil at 100 °C is at least 3.8 cST, which is pumpable even at -40 °C. What issues should be considered when changing engine oil? Vehicle should be in 'stop' position and on a flat surface. The engine oil must be drained when hot. Ensure that the old oil in the engine crankcase fully discharged, whether used oil in engine pan is empty and whether pan bung is mounted properly. How can waste engine oils be recycled? PETDER serves free of charge regardless of quantity and distance throughout Turkey with its waste engine oil collecting organization. Waste producers may contact PETDER as the Authorized Establishment through the website www.petder.org.tr, via e-mail atikyag@petder.org.tr or via telephone 0212-229 39 99 to gain information or to have waste oil they collected in accordance with principals of regulation collected. The collecting process is monitored on satellite with central planning and is conducted by vehicles appropriate to EU standards and trained staff. Grease What are the intended uses of grease? With manual hand pump or air pump can be printed directly into the bearing. In systems with central automatic lubrication, the grease is filled into the central chamber, the pneumatic system greases the greasing points automatically with the specified intervals. Where is grease used? In terms of application of lubricating with oil where it is not possible to use grease especially in ball bearings. What are the conditions to keep grease? Greases may leak during storage and base oil also tends to oscillate. The oil leakage rate will increase over time and will vary depending on the storage temperature. The grease should ideally be stored in a cool, dry interior and the ambient temperature should not exceed 30 °C and should not be less than 0 °C. The grease must be protected from dust, dirt, moisture or rainwater, and from direct sunlight. ALL QUESTIONS